procedures manual glass cutting machine |
Date:2013-10-09 Author:zhaoyang Hits:1366 |
Preparation before cutting
1 must be carefully checked before using the device performance , ensuring the integrity of the various components .
2 Power knife switch , saw the tightness of blade guard or safety baffles detailed examination , console must be stable, night work should have enough illumination .
3 Before use, first open the master switch, load test turn laps , to be confirmed safe and correct before allowed to start.
4 before the operation must review whether the electric power tool on conventional voltage matches the rated 220VA , 380VA received in order to avoid the wrong power source .
Cutting Considerations
1.manual glass cutting machine you are doing and not only to keep a clear head , but also to rational operating a power tool . Prohibited tired , drunk or taking stimulant medication after the operation manual glass cutting machine.
2 power supply line must be safe , reliable, non- privately Luanla , carefully place the power cord , do not be cut off. Must be carefully checked before using the device's performance to ensure that all parts intact.
3 . Wear appropriate clothes, can not wear loose clothing , not wearing jewelry or long hair , is strictly prohibited without wearing gloves and cuff buckle and operation.
4 of the workpiece must be clamped firmly prohibited workpiece clamping is not tight to start cutting .
5 . Prohibited in wheel plane workpiece grinding burr grinding wheel to prevent fragmentation .
6 The operator must deviate cutting grinding wheel front and goggles .
7 Do not use the grinding wheel has been mutilated , cut should be to prevent Mars scattered and away from flammable materials .
8 workpiece clamping fixture should be smooth solid , shields must be installed correctly, after clamping air operation should start checking , without vibration and abnormal noise.
9 midway replaced with new cutting disc or grinding wheel piece , do not tighten the nut with excessive force, preventing blade or grinding wheel crack accidents.
10 It must be stable grip manual glass cutting machine handles evenly vertical incision , and the fixed end to a solid and reliable .
11 Do not attempt to cut saws unclamped small workpiece or with a serious edge profiles.
12 In order to improve work efficiency. Together for single or multi-branch sawing , be sure to do a good job supporting fixture positioning .
13 may not be strong sawing operation , before cutting to reach full speed until the motor speed can be.
14 allow anyone to stand behind saws , power failure , rest or leave the work place , immediately turn off the power .
15 blade shall not stop on the workpiece from a saw or a hand or loosen any lift arm.
16 shall not be operated when the guard is not in place , can not put your hands away from the blade 15 cm or less. Not lean over or bypassing saw, operation body Xiece 45 degrees is appropriate .
17 appear to have unusual sounds , immediately stop checking ; repair or replacement of parts must be cut off before the power and other blade has completely stopped.
18 Using manual glass cutting machine in damp places such as work, must stand on dry insulating mats or on the board . Ascend or explosion hazardous areas such as safety precautions must be prepared to use .
19 shakes and other equipment failures, should immediately stop repair , prohibited ill and taking stimulants and drink operations, operations are forbidden to wear gloves . If during operation will cause dust, wear a mask or face shield.
20. Process should be finished off , and make cleaning equipment and surrounding venues . |
Previous: Distinguish crystal , diamonds, Rhodochrosite , glass method |
Next: The notes for using EVA film in laminating glass making |
TELL:+86 1902521703 Cell:+8615866605088(wechat/whatsapp)
@: brady0086@hotmail.com Wechat:brady0086 Skype:brady0086 QQ:1156692876
ADD:3966 ERHUANDONG ROAD,JINAN,250013,CHINA